Click here

REAR DOOR BELT MOULDING INSTALLATION

Click here
Click here Click here
Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

Click here
  1. Click here

    INSTALL REAR DOOR BELT MOULDING ASSEMBLY LH


    1. Attach the claw to install the belt moulding.

  2. Click here

    INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH


    1. A01572Z

      Slide the rear door glass sub-assembly LH as shown in the illustration to install it.

  3. Click here

    INSTALL REAR DOOR QUARTER WINDOW GLASS LH


    1. A0158VK

      Install the rear door quarter window glass LH together with the rear door quarter window weatherstrip LH in the direction indicated by the arrow in the illustration.

  4. Click here

    INSTALL REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY LH


    1. Install the rear door rear lower window frame sub-assembly LH with the 2 bolts and screw.

  5. Click here

    INSTALL REAR DOOR GLASS RUN LH


    1. Install the rear door glass run LH.

  6. Click here

    INSTALL REAR DOOR SERVICE HOLE COVER LH


    1. Apply butyl tape to the door.

    2. A015AG6

      Pass the rear door lock remote control cable assembly LH and rear door inside locking cable assembly LH through a new rear door service hole cover LH.

      Note:

      • When installing the rear door service hole cover LH, pull the links and connectors through the rear door service hole cover LH.

      • There should be no wrinkles or folds after attaching the rear door service hole cover LH.

      • After attaching the rear door service hole cover LH, check the sealing quality.

    3. Connect the 2 connectors.

    4. Attach the 6 clamps.

    5. A015BL3E01

      Install the bolt as shown in the illustration.

      8.4 N*m 86 kgf*cm 74 in.*lbf
  7. Click here

    INSTALL REAR INNER DOOR GLASS WEATHERSTRIP LH


    1. A015905E02

      Install the rear inner door glass weatherstrip LH to the door panel.

  8. Click here

    INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. Connect the connector.

    2. A0157I9

      Connect the rear door lock remote control cable assembly LH and rear door inside locking cable assembly LH to the rear door inside handle sub-assembly LH.

    3. A015D8Q

      Attach the 4 claws and 9 clips to install the rear door trim board sub-assembly LH.

    4. Install the 3 screws.

  9. Click here

    INSTALL ASSIST GRIP COVER LH


    1. Attach the 9 claws to install the assist grip cover LH to the rear door trim board sub-assembly LH.

  10. Click here

    INSTALL REAR DOOR ARMREST BASE PANEL ASSEMBLY LH


    1. Connect the connector.

    2. A01561H

      Attach the 7 claws to install the armrest base panel.

  11. Click here

    INSTALL REAR DOOR INSIDE HANDLE BEZEL LH


    1. Attach the 4 claws to install the rear door inside handle bezel LH.

  12. Click here

    CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).