HAZARD WARNING SWITCH REMOVAL

Tech Tips


  • Use the same procedures for the RHD and LHD.

  • The procedures listed below are the LHD side.


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY

    A015A0J

    1. Detach the 8 claws and remove the opening cover.

  3. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

    A0157IUE02
    Text in Illustration
    *1 Protective Tape

    1. Place protective tape as shown in the illustration.

    2. Using a moulding remover, detach the 6 claws.

    3. Disconnect the connector and remove the No. 3 instrument panel register.

  4. REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

    A015DBME02
    Text in Illustration
    *1 Protective Tape

    1. Place protective tape as shown in the illustration.

    2. Using a moulding remover, detach the 6 claws.

    3. Disconnect the connector and remove the No. 4 instrument panel register.

  5. REMOVE RADIO RECEIVER ASSEMBLY (w/ Radio Receiver)


    1. A0158M9

      Remove the 2 screws and 2 bolts.

    2. Disconnect the connectors and remove the radio receiver.

  6. REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL (w/o Radio Receiver)

    A015A0J

    1. Detach the 8 claws and remove the opening cover.

  7. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY


    1. A0158QL

      Detach the 2 claws and remove the hazard warning switch.