WASHER NOZZLE (for Front Side) REMOVAL

Tech Tips


  • Use the same procedure for the LH and RH sides.

  • The procedure listed below is for the LH side.


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE UPPER RADIATOR SUPPORT SEAL


    1. Remove the 7 clips and radiator support seal.

      A015BVKE02

  4. REMOVE FRONT FENDER MAIN SEAL LH


    1. A0155CK

      Using a clip remover, detach the 3 clips and remove the fender main seal.

  5. REMOVE FRONT FENDER MAIN SEAL RH

    Tech Tips

    Use the same procedure described for the LH side.

  6. REMOVE FRONT WIPER ARM LH


    1. Remove the nut, wiper arm and blade.

  7. REMOVE FRONT WIPER ARM RH


    1. Remove the nut, wiper arm and blade.

  8. REMOVE HOOD TO COWL TOP SEAL


    1. A0155QV

      Using a clip remover, detach the 12 clips, 4 clamps and remove the hood to cowl top seal.

  9. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY


    1. A015DL2

      Remove the washer hose.

    2. A0157PP

      Remove the 2 clips.

    3. Detach the 17 claws and remove the cowl top ventilator louver sub-assembly.

  10. REMOVE WASHER NOZZLE SUB-ASSEMBLY (w/o PTC Heater)


    1. A0157N4

      Detach the 3 claws and remove the washer nozzle.

    2. Disconnect the hose.

  11. REMOVE WASHER NOZZLE SUB-ASSEMBLY (w/ PTC Heater)


    1. A015CR6

      Detach the connector clamp and disconnect the connector.

    2. Disconnect the hose.

    3. A0158H3

      Detach the 4 claws and remove the washer nozzle.