Click here

WIPER ECU INSTALLATION

Click here
Click here Click here
Tip:

  • Use the same procedure for LHD and RHD vehicles.

  • The procedure listed below is for LHD vehicles.

Click here
  1. Click here

    INSTALL WINDSHIELD WIPER ECU


    1. A015ACU

      Install the windshield wiper ECU with the screw.

    2. Connect the 2 connectors.

  2. Click here

    INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL


    1. Connect the connector.

    2. Attach the 3 claws to install the lower No. 2 instrument panel finish panel.

    3. Install the 4 bolts.

  3. Click here

    INSTALL INSTRUMENT PANEL BOX DOOR KNOB


    1. Attach the 2 claws to install the instrument panel box door knob.

  4. Click here

    INSTALL NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH


    1. Attach the 6 claws to install the No. 3 instrument cluster finish panel garnish.

  5. Click here

    INSTALL LOWER INSTRUMENT PANEL (w/o Passenger Side Knee Airbag)


    1. Attach the 4 claws to install the lower instrument panel.

    2. Install the 2 bolts.

  6. Click here

    INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY (w/ Passenger Side Knee Airbag)


    1. A015670E01

      Connect the connector.

      Note:

      When handling the airbag connector, take care not to damage the airbag wire harness.

    2. Attach the 4 claws to install the front passenger side knee airbag.

    3. Install the 4 bolts.

      10 N*m 102 kgf*cm 7 ft.*lbf
  7. Click here

    INSTALL FRONT DOOR SCUFF PLATE RH

    Tip:

    Use the same procedures described for the LH side.

  8. Click here

    INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)


    1. Attach the 4 claws to install the No. 2 instrument panel under cover.

  9. Click here

    INSTALL INSTRUMENT SIDE PANEL RH (w/ Airbag Cut Off Switch)


    1. Connect the connector.

    2. Attach the 6 claws to install the instrument side panel.

  10. Click here

    INSTALL INSTRUMENT SIDE PANEL RH (w/o Airbag Cut Off Switch)


    1. Attach the 6 claws to install the instrument side panel.

  11. Click here

    CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  12. Click here

    CHECK SRS WARNING LIGHT

    (Click here)