DESCRIPTION
The power back door unit assembly (power back door ECU) receives the power back door ON/OFF switch signal to sound the power back door warning buzzer.
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
PERFORM ACTIVE TEST USING INTELLIGENT TESTER (PBD BUZZER)
Select the Active Test, use the intelligent tester to generate a control command, and check that the power back door warning buzzer sounds Click here.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| PBD Buzzer | Operate warning buzzer | ON / OFF | - |
| OK |
|---|
| Power back door warning buzzer sounds normally. |
| NG |
|
CHECK HARNESS AND CONNECTOR (POWER BACK DOOR WARNING BUZZER - POWER BACK DOOR UNIT ASSEMBLY AND BODY GROUND) Click here |
| OK |
|
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here
CHECK HARNESS AND CONNECTOR (POWER BACK DOOR WARNING BUZZER - POWER BACK DOOR UNIT ASSEMBLY AND BODY GROUND)
Disconnect the K47 power back door warning buzzer connector.
Disconnect the L52 power back door unit assembly connector.
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
| OK |
|
REPLACE POWER BACK DOOR WARNING BUZZER
Temporarily replace the power back door warning buzzer with a new or normally functioning one Click here.
| NEXT |
|
PERFORM ACTIVE TEST USING INTELLIGENT TESTER (PBD BUZZER)
Select the Active Test, use the intelligent tester to generate a control command, and check that the power back door warning buzzer sounds Click here.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| PBD Buzzer | Operate warning buzzer | ON / OFF | - |
| OK |
|---|
| Power back door warning buzzer sounds normally. |
| NG |
|
REPLACE POWER BACK DOOR UNIT ASSEMBLY Click here |
| OK |
|
END (POWER BACK DOOR WARNING BUZZER IS DEFECTIVE)