SLIDING ROOF HOUSING INSTALLATION


  1. INSTALL SLIDING ROOF HOUSING SUB-ASSEMBLY


    1. Temporarily install the housing with the 8 bolts (vehicle body side) and 8 nuts.

    2. Tighten the 8 nuts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    3. Tighten the 8 bolts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }
      A015E5F

  2. INSTALL SLIDING ROOF WEATHERSTRIP

    A015ASDE01

    1. Install the sliding roof weatherstrip as described below.


      1. Attach each corner of the weatherstrip so that each weatherstrip mark is aligned with the sliding roof glass center mark. After attaching the entire weatherstrip, check that all weatherstrip marks are within the sliding roof glass end marks.

      2. Make sure the weatherstrip cutout is toward the rear side of the vehicle and centered.

      3. Make sure the weatherstrip is securely installed as shown in the illustration.

  3. INSTALL SLIDING ROOF GLASS SUB-ASSEMBLY


    1. A0159GK

      Using a T25 "TORX" driver, temporarily install the glass with the 4 screws.

    2. Perform a level check.


      1. Check the difference in the level between the roof panel and the upper surface of the weatherstrip labeled "a" when the sliding roof glass is fully closed.

        Standard
        Area Specified Condition
        A - A 0 +/-1.5 mm (0 +/-0.0591 in.)
        B - B
        C - C
        D - D

        Tech Tips

        "+" represents the condition that the glass is above the panel level. "-" represents the condition that the glass is below the panel level.

      2. Perform a gap check.

        Check the gap between the roof panel and roof glass.

        Note

        The gap must be even all around.

        A015932E01
    3. A0159GK

      Tighten the 4 screws.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

  4. CHECK FOR WATER LEAK


    1. After adjusting the sliding roof glass sub-assembly, check for water leaks.

    2. If there are any leaks, readjust the sliding roof glass sub-assembly.

  5. INSTALL SLIDING ROOF SIDE GARNISH LH

    A0157Z0

    1. Attach the 5 claws to install the sliding roof side garnish.

  6. INSTALL SLIDING ROOF SIDE GARNISH RH

    Tech Tips

    Use the same procedures described for the LH side.

  7. INSTALL REAR NO. 5 ROOF AIR DUCT


    1. A0156N0

      Attach the 2 clips to install the duct.

  8. INSTALL REAR NO. 4 ROOF AIR DUCT

    Tech Tips

    Use the same procedures described for the No. 5 roof air duct.

  9. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH


    1. Install the curtain shield airbag Click here.

  10. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY RH

    Tech Tips

    Use the same procedures described for the LH side.

  11. INSTALL ROOF HEADLINING ASSEMBLY


    1. Install the roof headlining Click here.

  12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  13. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.