POWER WINDOW REGULATOR MOTOR (for Front Door) INSTALLATION

INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY

1. 

   Apply MP grease to the sliding and rotating areas of the front door window regulator sub-assembly LH.

   Note:

   Do not apply grease to the spring of the front door window regulator sub-assembly LH.

   Table 1. Text in Illustration

   *1	Temporary Bolt

2. Loosely install the temporary bolt onto the front door window regulator sub-assembly LH.

3. Insert the front door window regulator sub-assembly LH into the door panel. Use the temporary bolt to hang the front door window regulator sub-assembly LH on the door panel.

   Note:

   Be careful not to drop the front door window regulator sub-assembly LH as it may become damaged.

4. Temporarily install the front door window regulator sub-assembly LH with the 5 bolts.

5. Tighten the 6 bolts in the order shown in the illustration.

   8.0 N*m

   82 kgf*cm

   71 in.*lbf

INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

1. 

   Insert the front door glass sub-assembly LH into the door panel along the glass run as indicated by the arrows in the illustration.

   Note:

   Be careful not to damage the glass.

2. Install the front door glass sub-assembly LH to the front door window regulator sub-assembly LH with the 2 bolts.

   8.0 N*m

   82 kgf*cm

   71 in.*lbf

INSTALL FRONT DOOR SERVICE HOLE COVER

1. 

   Apply butyl tape to the door.

2. Pass the front door lock remote control cable assembly LH and front door inside locking cable assembly LH through a new front door service hole cover LH.

   Note:
   

   • When installing the front door service hole cover LH, pull the links and connectors through the front door service hole cover LH.

   • There should be no wrinkles or folds after attaching the front door service hole cover LH.

   • After attaching the front door service hole cover LH, check the sealing quality.

3. 

   Connect the 2 connectors.

4. Attach the 9 clamps.

5. Install the bolt as shown in the illustration.

   8.4 N*m

   86 kgf*cm

   74 in.*lbf

INSTALL FRONT NO. 1 SPEAKER ASSEMBLY

1. 

   Connect the speaker connector.

2. Install the speaker with the 4 screws.

   Note:

   Do not touch the cone part of the speaker.

INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

1. 

   Connect the connector.

2. Connect the front door lock remote control cable assembly LH and front door inside locking cable assembly LH to the front door inside handle sub-assembly LH.

3. 

   Attach the 4 claws and 13 clips to install the front door trim board sub-assembly LH.

4. Install the 3 screws.

INSTALL DOOR ASSIST GRIP COVER

1. Attach the 8 claws to install the door assist grip cover LH to the front door trim board sub-assembly LH.

INSTALL FRONT DOOR ARMREST BASE PANEL ASSEMBLY

1. Connect the connector.

2. 

   Attach the 5 claws to install the armrest base panel.

INSTALL FRONT DOOR INSIDE HANDLE BEZEL

1. 

   Attach the 4 claws to install the front door inside handle bezel LH.

INSTALL FRONT LOWER DOOR FRAME BRACKET GARNISH

1. Attach the clip and claw, and install the front door lower frame bracket garnish LH.