MULTI-DISPLAY (w/ Navigation System) REMOVAL


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY

    A015A0J

    1. Detach the 8 claws and remove the opening cover.

  4. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

    A0157IUE02
    Text in Illustration
    *1 Protective Tape

    1. Place protective tape as shown in the illustration.

    2. Using a moulding remover, detach the 6 claws.

    3. Disconnect the connector and remove the No. 3 instrument panel register.

  5. REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

    A015DBME02
    Text in Illustration
    *1 Protective Tape

    1. Place protective tape as shown in the illustration.

    2. Using a moulding remover, detach the 6 claws.

    3. Disconnect the connector and remove the No. 4 instrument panel register.

  6. REMOVE MULTI-DISPLAY ASSEMBLY


    1. A015CPE

      Remove the 2 screws and 2 bolts.

    2. A0155D4

      Pull the multi-display assembly to detach the 2 clips and 6 claws on the backside of the multi-display assembly.

    3. Disconnect the connectors and remove the multi-display assembly.

  7. REMOVE NO. 1 RADIO RECEIVER BRACKET


    1. A015ALY

      Remove the 4 bolts and No. 1 radio receiver bracket.