Click here

STEREO JACK ADAPTER ASSEMBLY REMOVAL

Click here
Click here Click here
  1. Click here

    PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

  2. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  3. Click here

    REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION


    1. A015BCWE02

      Place protective tape as shown in the illustration.

    2. Using a moulding remover, detach the 7 claws and remove the panel cushion.

  4. Click here

    REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH


    1. A015D40

      Remove the clip.

    2. Remove the screw.

    3. Detach the 8 claws.

    4. Remove the panel pad and disconnect the connectors and 2 clamps.

  5. Click here

    REMOVE NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION


    1. A015CGBE01

      Place protective tape as shown in the illustration.

    2. Using a moulding remover, detach the 7 claws and remove the panel cushion.

  6. Click here

    REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH


    1. A015BRH

      Remove the clip.

    2. Remove the screw.

    3. Detach the 7 claws and remove the panel.

  7. Click here

    REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY


    1. A0156X3E01

      Twist the shift lever knob in the direction indicated by the arrow and remove it.

  8. Click here

    REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    1. A01574Y

      Detach the 7 claws.

    2. Disconnect the connectors and remove the panel.

  9. Click here

    REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY


    1. A015C68

      Detach the 9 claws and remove the panel.

  10. Click here

    REMOVE CONSOLE CUP HOLDER BOX SUB-ASSEMBLY


    1. A015CM5

      Detach the 4 claws and remove the box.

  11. Click here

    REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


    1. A015CZ0

      Detach the 14 claws.

    2. Disconnect the connectors and remove the console panel.

  12. Click here

    REMOVE NO. 1 STEREO JACK ADAPTER ASSEMBLY


    1. A015BEH

      Detach the 2 claws and remove the stereo jack adapter.

  13. Click here

    REMOVE REAR CONSOLE END PANEL SUB-ASSEMBLY


    1. A01581GE01

      Place protective tape as shown in the illustration.

    2. Using a moulding remover, detach the 8 claws.

    3. Remove the end panel and disconnect the connectors and 2 clamps.

  14. Click here

    REMOVE HEADPHONE TERMINAL


    1. A01576UE01

      Remove the 2 screws.

    2. Detach the connector clamp.

    3. A0156RJ

      Detach the 4 claws and remove the terminal.