FRONT DOOR SPEAKER REMOVAL

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH


    1. A015B4R

      Detach the clip and claw, and remove the front door lower frame bracket garnish LH.

  4. REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH


    1. A015C7WE01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, detach the 4 claws and remove the front door inside handle bezel LH.

      Tech Tips

      Tape the screwdriver tip before use.

  5. REMOVE FRONT DOOR ARMREST BASE PANEL ASSEMBLY LH

    A01560C

    1. Using a moulding remover, detach the 5 claws.

    2. Disconnect the connector and remove the armrest base panel.

  6. REMOVE DOOR ASSIST GRIP COVER LH


    1. A0157Y7

      Using a moulding remover, detach the 8 claws and remove the door assist grip cover LH.

  7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. A015E4QE01

      Remove the 3 screws.

    2. Remove the 13 clips.

    3. Remove the front inner door glass weatherstrip LH together with the front door trim board sub-assembly LH by pulling them upward in the order shown in the illustration.

      Tech Tips

      Make sure that the pin labeled A in the illustration is detached from the door panel.

    4. Disconnect the connector.

    5. A015CXP

      Disconnect the 2 cables from the front door inside handle sub-assembly LH.

  8. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY


    1. Disconnect the speaker connector.

    2. A015915

      Remove the 4 screws and speaker.

      Note

      Do not touch the cone part of the speaker.