RADIO RECEIVER (w/o Stereo Component Amplifier) REMOVAL


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY

    A015A0J

    1. Detach the 8 claws and remove the opening cover.

  4. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

    A0157IUE02
    Text in Illustration
    *1 Protective Tape

    1. Place protective tape as shown in the illustration.

    2. Using a moulding remover, detach the 6 claws.

    3. Disconnect the connector and remove the No. 3 instrument panel register.

  5. REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

    A015DBME02
    Text in Illustration
    *1 Protective Tape

    1. Place protective tape as shown in the illustration.

    2. Using a moulding remover, detach the 6 claws.

    3. Disconnect the connector and remove the No. 4 instrument panel register.

  6. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL CENTER


    1. A015BUW

      Detach the 10 claws on the backside of the cluster finish panel to remove it.

  7. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET


    1. A0158M9

      Remove the 2 screws and 2 bolts.

    2. Disconnect the connectors and remove the radio receiver.

  8. REMOVE NO. 1 RADIO BRACKET


    1. A0158R3

      Remove the 3 bolts and bracket.

  9. REMOVE NO. 2 RADIO BRACKET


    1. A0155FR

      Remove the 3 bolts and bracket.

  10. REMOVE CLOCK ASSEMBLY


    1. A01574D

      Remove the 2 screws and clock.

  11. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY


    1. A0158QL

      Detach the 2 claws and remove the hazard warning switch.