Click here

VANE PUMP (for 3UR-FE) REMOVAL

Click here
Click here Click here
  1. Click here

    PRECAUTION

    Note:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

  2. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  3. Click here

    REMOVE FRONT WHEEL RH

  4. Click here

    REMOVE FRONT FENDER APRON TRIM PACKING A


    1. A015AN4

      Using a clip remover, remove the 3 clips and fender apron seal.

  5. Click here

    REMOVE V-BANK COVER SUB-ASSEMBLY


    1. A015DFWE03

      Raise the front of the V-bank cover to detach the 3 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.

      Table 1. Text in Illustration
      *1 Bracket
      *2 Hook
      *3 Pin
      *4 Grommet
  6. Click here

    REMOVE AIR CLEANER HOSE ASSEMBLY


    1. A0155X9

      Disconnect the vacuum hose and No. 2 ventilation hose.

    2. Loosen the 2 hose clamps.

    3. Remove the air cleaner hose.

  7. Click here

    REMOVE AIR CLEANER ASSEMBLY


    1. A0157H2

      Remove the 3 bolts and air cleaner.

  8. Click here

    REMOVE FAN AND GENERATOR V BELT


    1. A015D9JE03

      While turning the belt tensioner counterclockwise, align the service hole for the belt tensioner and the belt tensioner fixing position, and then insert a bar of 5 mm (0.197 in.) into the service hole to fix the belt tensioner in place.

      Table 2. Text in Illustration
      *1 Bar
      Tip:

      The pulley bolt for the belt tensioner has a left-hand thread.

    2. Remove the V belt.

  9. Click here

    DRAIN POWER STEERING FLUID

  10. Click here

    DISCONNECT POWER STEERING OIL PRESSURE SENSOR CONNECTOR


    1. A015D11

      Detach the wire harness clamp and disconnect the connector.

  11. Click here

    DISCONNECT PRESSURE FEED TUBE


    1. A0155AEE04

      Remove the bolt and disconnect the pressure feed tube.

      Table 3. Text in Illustration
      *1 Pressure feed tube

    2. Remove the gasket.

  12. Click here

    DISCONNECT SUCTION HOSE


    1. A015C28

      Slide the clip and disconnect the suction hose from the vane pump.

  13. Click here

    REMOVE VANE PUMP ASSEMBLY


    1. A0158UP

      Remove the 2 bolts and vane pump.