AIR CONDITIONING PANEL (w/ Multi-display) REMOVAL

Tech Tips


  • Use the same procedures for the LHD vehicle and RHD vehicle.

  • The procedures listed below are for the LHD vehicle.


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY

    A015A0J

    1. Detach the 8 claws and remove the opening cover.

  4. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

    A0157IUE02
    Text in Illustration
    *1 Protective Tape

    1. Place protective tape as shown in the illustration.

    2. Using a moulding remover, detach the 6 claws.

    3. Disconnect the connector and remove the No. 3 instrument panel register.

  5. REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

    A015DBME02
    Text in Illustration
    *1 Protective Tape

    1. Place protective tape as shown in the illustration.

    2. Using a moulding remover, detach the 6 claws.

    3. Disconnect the connector and remove the No. 4 instrument panel register.

  6. REMOVE MULTI-DISPLAY ASSEMBLY WITH BRACKET


    1. A015CPE

      Remove the 4 bolts.

    2. A0155D4

      Pull the radio receiver to detach the 8 claws on the backside of the radio receiver.

    3. Disconnect the connectors and remove the radio receiver.