Click here

SKID CONTROL BUZZER REMOVAL

Click here
Click here Click here
  1. Click here

    PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

  2. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  3. Click here

    REMOVE FRONT DOOR SCUFF PLATE

  4. Click here

    REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. Remove the 2 screws.

    2. Detach the 3 claws.

    3. Disconnect the connectors and remove the No. 1 instrument panel under cover.

  5. Click here

    REMOVE COWL SIDE TRIM BOARD


    1. Remove the cap nut.

    2. Detach the 2 clips and remove the cowl side trim board.

  6. Click here

    REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL


    1. Using a screwdriver, detach the 2 claws and open the hole cover.

      Tip:

      Tape the screwdriver tip before use.

      Table 1. Text in Illustration
      *1 Protective Tape

    2. w/ Driver Side Knee Airbag:


      1. Remove the 2 bolts.

      2. A015CUJ

        Detach the 16 claws.

    3. w/o Driver Side Knee Airbag:


      1. Remove the 2 bolts.

      2. A015A9A

        Detach the 9 claws.

    4. A0158MF

      for Automatic Air Conditioning System:


      1. Detach the 2 claws and remove the room temperature sensor.

    5. A0156SA

      Detach the 2 claws and disconnect the 2 control cables.

    6. Disconnect the connectors and remove the lower No. 1 instrument panel finish panel.

  7. Click here

    REMOVE NO. 1 SWITCH HOLE BASE


    1. Detach the 4 claws.

    2. Disconnect the connectors and remove the No. 1 switch hole cover.

  8. Click here

    REMOVE SKID CONTROL BUZZER ASSEMBLY (for LHD)


    1. A0156O0

      Detach the clamp and remove the buzzer.

    2. Disconnect the buzzer connector.

  9. Click here

    REMOVE SKID CONTROL BUZZER ASSEMBLY (for RHD)


    1. A015BMT

      Detach the clamp and remove the buzzer.

    2. Disconnect the buzzer connector.