Click here

YAW RATE AND DECELERATION SENSOR (w/ VSC) INSTALLATION

Click here
Click here Click here
  1. Click here

    INSTALL YAW RATE SENSOR


    1. Connect the sensor connector, and then attach the clamp to the hole of the sensor bracket.

      Note:

      Securely connect the connector.

    2. Install the yaw rate sensor with the 2 bolts.

      15 N*m 148 kgf*cm 11 ft.*lbf
      Note:

      • Make sure that the sensor is oriented correctly.

      • If the sensor is dropped, replace it.

      • A0158RUE01
        A015E2BE01

        When installing the sensor, make sure to avoid impacts to the sensor.

  2. Click here

    INSTALL COOLING BOX ASSEMBLY (w/ Cool Box)

    (Click here)

  3. Click here

    INSTALL REAR CONSOLE BOX SUB-ASSEMBLY (w/o Cool Box)

    (Click here)

  4. Click here

    CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  5. Click here

    PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION


    1. Perform the yaw rate sensor zero point calibration (Click here).

  6. Click here

    CHECK YAW RATE SENSOR SIGNAL


    1. Check the yaw rate sensor signal (Click here).