REAR SPEED SENSOR

Click here
INSTALL REAR SPEED SENSOR LH
1. Install the speed sensor with the nut.
  
  8.3 N*m 85 kgf*cm 73 in.*lbf
  Note:
  - Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
  - While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip.
  - After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the knuckle.
  - Make sure there is no foreign matter attached to the speed sensor rotor.
Click here
INSTALL REAR SPEED SENSOR RH
1. Install the speed sensor with the nut.
  
  8.3 N*m 85 kgf*cm 73 in.*lbf
  Note:
  - Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
  - While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip.
  - After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the knuckle.
  - Make sure there is no foreign matter attached to the speed sensor rotor.
Click here
INSTALL SKID CONTROL SENSOR WIRE
1. Install the sensor clamp with the bolt.
  
  13 N*m 127 kgf*cm 9 ft.*lbf
  
  Note:
  Make sure the clamp rotation stopper touches the installation position.
2. Connect the connector.
  Note:
  - Securely insert the connector.
  - When connecting the connector, do not twist the wire harness.
3. Install the sensor clamp with the bolt.
  
  13 N*m 127 kgf*cm 9 ft.*lbf
  
  Note:
  Make sure the clamp rotation stopper touches the installation position.
4. Connect the speed sensor RH connector.
  Note:
  - Securely connect the connector.
  - When connecting the connector, do not twist the wire harness.
5. Attach the 3 clamps.
  Note:
  - When attaching the clamps, do not twist the wire harness.
  - When attaching the clamps, securely insert them as shown in the illustration.
6. Attach the 5 clamps.
  Note:
  - When attaching the clamps, do not twist the wire harness.
  - When attaching the clamps, securely insert them as shown in the illustration.
7. Attach the 2 clamps, and install the sensor clamp with the bolt.
  
  13 N*m 127 kgf*cm 9 ft.*lbf
8. Connect the speed sensor LH connector.
  Note:
  - Securely connect the connector.
  - When connecting the connector, do not twist the wire harness.

INSTALL REAR WHEEL

for Aluminum Wheel
131 N*m	1336 kgf*cm	97 ft.*lbf
for Steel Wheel
209 N*m	2131 kgf*cm	154 ft.*lbf

Click here
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Note:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
Click here
CHECK SPEED SENSOR SIGNAL
1. w/ ABS:
  
  Check the speed sensor signal (Click here).
2. w/ VSC:
  
  Check the speed sensor signal (Click here).

REAR SPEED SENSOR INSTALLATION