REAR SPEED SENSOR REMOVAL


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE REAR WHEEL

  4. REMOVE SKID CONTROL SENSOR WIRE


    1. A0158PC

      Disconnect the speed sensor LH connector.

    2. Detach the 2 clamps and remove the bolt and sensor clamp.

      A015681E01

    3. Detach the 5 clamps.

      A01598H

    4. Detach the 3 clamps.

      A015596
    5. A0156HL

      Disconnect the speed sensor RH connector.

    6. A0156U2E01

      Remove the bolt.

    7. A0157UOE01

      Disconnect the connector, and remove the bolt and skid control sensor wire.

  5. REMOVE REAR SPEED SENSOR LH


    1. A01555A

      Remove the nut and speed sensor.

      Note

      Pull out the sensor while trying as much as possible not to rotate it.

  6. REMOVE REAR SPEED SENSOR RH


    1. A0158PJ

      Remove the nut and speed sensor.

      Note

      Pull out the sensor while trying as much as possible not to rotate it.