BRAKE PEDAL (for LHD) REMOVAL


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT DOOR SCUFF PLATE LH

    A0157IK

    1. Detach the 7 claws and 4 clips, and remove the scuff plate.

  4. REMOVE COWL SIDE TRIM BOARD LH

    A0156SP

    1. Remove the cap nut.

    2. Detach the 2 clips and remove the cowl side trim board.

  5. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    A0159IW

    1. Remove the 2 screws.

    2. Detach the 3 claws.

    3. Disconnect the connectors and remove the No. 1 instrument panel under cover.

  6. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

    A015CNPE02

    1. Using a screwdriver, detach the 2 claws and open the hole cover.

      Tech Tips

      Tape the screwdriver tip before use.

      Text in Illustration
      *1 Protective Tape

    2. w/ Driver Side Knee Airbag:


      1. Remove the 2 bolts.

      2. Detach the 16 claws.

        A015CUJ

    3. w/o Driver Side Knee Airbag:


      1. Remove the 2 bolts.

      2. Detach the 9 claws.

        A015A9A
    4. A0158MF

      for Automatic Air Conditioning System:


      1. Detach the 2 claws and remove the room temperature sensor.

    5. A0156SA

      Detach the 2 claws and disconnect the 2 control cables.

    6. Disconnect the connectors and remove the lower No. 1 instrument panel finish panel.

  7. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY


    1. A015A6DE01

      Remove the 5 bolts and driver side knee airbag.

    2. Disconnect the connector.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

  8. REMOVE PUSH ROD PIN


    1. A0157EGE01

      Remove the clip and push rod pin from the brake pedal lever.

  9. REMOVE STOP LIGHT SWITCH ASSEMBLY


    1. Disconnect the stop light switch connector.

    2. Remove the stop light switch Click here.

  10. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY


    1. A015CI3E01

      Loosen the hexagon bolt.

      Tech Tips

      Hold the bolt in place and loosen the nut.

      Note

      Only loosen the nut. Do not remove the bolt or nut.

    2. Remove the brake pedal support reinforcement set bolt.

    3. A015CY0E01

      Remove the 4 nuts and brake pedal support assembly.