SUSPENSION CONTROL ECU INSTALLATION


  1. INSTALL SUSPENSION CONTROL ECU


    1. A015E5I

      Attach the wire harness clamp and connect the connector.

    2. Install the ECU with the 2 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

  2. INSTALL REAR SIDE NO. 2 AIR DUCT (w/ Heater)

    A0155N3

    1. Install the duct with the 3 screws.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  3. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH

    A0157OV

    Tech Tips

    When installing the front quarter trim panel, operate the reclining adjuster release handle and move the No. 1 rear seat to the position shown in the illustration.


    1. w/ Rear No. 2 Seat, except Face to Face Seat Type:


      1. w/o Rear Air Conditioning System:

        Connect the rear seat lock control lever cable.

      2. w/ Rear Air Conditioning System:

        Connect the thermistor connector and rear seat lock control lever cable.

      3. Attach the 18 clips and 2 claws to install the quarter trim panel.

      4. Install the clip and bolt.

        Torque:
        12 N*m  { 122 kgf*cm, 9 ft.*lbf }
        A0157GF

    2. w/o Rear No. 2 Seat or w/ Rear No. 2 Seat, for Face to Face Seat Type:


      1. Attach the 18 clips and 2 claws to install the quarter trim panel.

      2. Install the clip.

        A0158HZ

    3. w/ Tonneau Cover:


      1. Attach the 18 clips and 2 claws to install the quarter trim panel.

      2. Install the screw and clip.

        A015ARP
    4. A0156NHE02

      w/ Rear No. 2 Seat, except Face to Face Seat Type:

      Install the rear No. 2 seat belt anchor with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

      Note

      Do not overlap the anchor part of the seat belt and protruding parts of the vehicle body.

    5. A015CT4

      Install the rear No. 1 seat belt anchor with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }
    6. A0158A5

      Attach the 3 claws to install the cover.

  4. INSTALL REAR SEAT COVER CAP (w/ Rear No. 2 Seat, except Face to Face Seat Type)

    A015E2E

    Tech Tips

    Use the same procedure to install the rear seat cover cap on the other side.


    1. Attach the 3 claws to install the rear seat cover cap.

  5. INSTALL NO. 1 TONNEAU COVER HOLDER CAP (w/ Tonneau Cover)

    A015DVZ

    Tech Tips

    Use the same procedure to install the tonneau cover holder cap on the other side.


    1. Attach the 2 claws to install the tonneau cover holder cap.

  6. INSTALL REAR FLOOR MAT REAR SUPPORT PLATE

    A015BES

    1. Attach the 6 clips to install the support plate.

  7. CLEAN REAR DOOR SCUFF PLATE LH

    A015BJQ

    1. Attach the 3 claws and 4 clips to install the scuff plate.

    2. Install the screw.

  8. CLEAN REAR STEP COVER

    A0159DZ

    Tech Tips

    Use the same procedure to install the step cover on the other side.


    1. Attach the 2 claws to install the step cover.

  9. INSTALL REAR NO. 2 SEAT ASSEMBLY LH (except Face to Face Seat Type)


    1. Install the rear No. 2 seat assembly LH Click here.

  10. INSTALL REAR NO. 2 SEAT ASSEMBLY RH (except Face to Face Seat Type)

    Tech Tips

    Use the same procedures described for the LH side.

  11. INSTALL REAR NO. 2 SEAT ASSEMBLY LH (for Face to Face Seat Type)


    1. Install the rear No. 2 seat assembly LH Click here.

  12. INSTALL REAR NO. 2 SEAT ASSEMBLY RH (for Face to Face Seat Type)

    Tech Tips

    Use the same procedures described for the LH side.

  13. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)


    1. Install the tonneau cover assembly.

  14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  15. PERFORM VEHICLE HEIGHT OFFSET CALIBRATION


    1. Perform the vehicle height offset calibration Click here.

  16. PERFORM ZERO POINT CALIBRATION OF G SENSOR


    1. Perform the zero point calibration of G sensor Click here.

  17. ADJUST HEADLIGHT ASSEMBLY


    1. for Standard:

      Adjust the headlight Click here.

    2. for HID Headlight:

      Adjust the headlight Click here.