GLOW PLUG REMOVAL

Note


  • When replacing an injector (including interchanging injectors between cylinders) or common rail, replace the corresponding injection pipes with new ones.

  • w/DPF

    When fuel lines are disconnected, air may enter the fuel lines, leading to engine starting trouble. Therefore, perform forced regeneration and bleed the air from the fuel lines.


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE INTERCOOLER ASSEMBLY (w/ Intercooler)

    Click here

  4. REMOVE INJECTION PIPES

    Click here

  5. REMOVE NO. 1 GLOW PLUG CONNECTOR


    1. Remove the 2 screw grommets and 2 nuts, and disconnect the 2 wire harnesses.

    2. A015DN4E01
      Text in Illustration
      *a RH
      *b LH

      Remove the 8 screw grommets, 8 nuts and 2 glow plug connectors.

  6. REMOVE GLOW PLUG ASSEMBLY


    1. A01580TE01
      Text in Illustration
      *a RH
      *b LH

      Using a 10 mm deep socket wrench, remove the 8 glow plugs.

      Tech Tips

      Before removing the glow plugs, thoroughly clean off all dirt, sand, etc.