Click here

TURBO MOTOR DRIVER REMOVAL

Click here
Click here Click here
  1. Click here

    PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

  2. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable some systems need to be initialized after the cable is reconnected (Click here).

  3. Click here

    REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH


    1. Remove the 3 bolts and 2 screws.

    2. Loosen the clip and remove the front fender splash shield RH.

  4. Click here

    REMOVE FRONT FENDER LINER RH


    1. Remove the screw and disconnect the liner from the front bumper cover.

    2. Using a T30 "TORX" socket, remove the 3 screws.

    3. Remove the 5 clips.

      Tip:

      It is not necessary to fully remove the fender liner. Partially remove it so that the air pump can be removed.

  5. Click here

    REMOVE TURBO MOTOR DRIVER


    1. A015AZ9E01

      Disconnect the connector.


      1. Disconnect the connector as follows: (1) push the claw upward, and (2) move the lock lever to release the lock.

    2. A015AD6

      Remove 2 nuts, bolt and turbo motor driver.