KNEE AIRBAG ASSEMBLY (for Front Passenger Side) REMOVAL

Tech Tips


  • Use the same procedures for the RHD and LHD.

  • The procedures listed below are the LHD side.


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE FRONT DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedures described for the LH side.

  3. REMOVE NO. 1 INSTRUMENT PANEL FINISH CUSHION

    A015CGBE02
    Text in Illustration
    *1 Protective Tape

    1. Put protective tape around the No. 1 instrument panel finish panel cushion.

    2. Using a moulding remover, detach the 7 claws and remove the No. 1 instrument panel finish panel cushion.

  4. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

    A015BRH

    1. Remove the clip and screw.

    2. Detach the 7 claws and remove the lower instrument panel pad sub-assembly.

  5. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)

    A015C2B

    1. Detach the 4 claws and remove the No. 2 instrument panel under cover.

  6. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY


    1. A01598PE01

      Remove the 4 bolts.

    2. Detach the 4 claws and remove the front passenger side knee airbag.

    3. Disconnect the connector.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.