KNEE AIRBAG ASSEMBLY (for Driver Side) INSTALLATION

Tech Tips


  • Use the same procedures for the RHD and LHD.

  • The procedures listed below are the LHD side.


  1. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY


    1. A01556EE01

      Connect the connector.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

    2. Install the driver side knee airbag with the 5 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

  2. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL


    1. Connect the connectors.

    2. A0158MF

      for Automatic Air Conditioning System:


      1. Attach the 2 claws to install the room temperature sensor.

    3. A0156SA

      Attach the 2 claws to connect the 2 control cables.

    4. w/ Driver Side Knee Airbag:


      1. Attach the 16 claws to install the lower No. 1 instrument panel finish panel.

      2. Install the 2 bolts.

        A015CUJ

    5. w/o Driver Side Knee Airbag:


      1. Attach the 9 claws to install the lower No. 1 instrument panel finish panel.

      2. Install the 2 bolts.

        A015A9A
    6. A015ATT

      Attach the 2 claws to close the hole cover.

  3. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)

    A015B20

    1. Connect the connectors.

    2. Attach the 3 claws to install the No. 1 instrument panel under cover.

    3. Install the 2 screws.

  4. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH


    1. Attach the 2 claws to install the No. 2 instrument cluster finish panel garnish.

      A0156L8E01
      Text in Illustration
      *A w/ Entry and Start System *B w/o Entry and Start System

  5. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

    A01555F

    1. Attach the 3 claws to install the No. 1 instrument cluster finish panel garnish.

  6. INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH

    A015BUX

    1. Connect the connectors and attach the 2 clamps.

    2. Attach the 8 claws to install the lower instrument panel pad sub-assembly.

    3. Install the clip and screw.

  7. INSTALL NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION

    A01556Z

    1. Attach the 7 claws to install the No. 1 instrument panel finish panel cushion.

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  9. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.