SPIRAL CABLE REMOVAL


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

  3. REMOVE LOWER NO. 3 STEERING WHEEL COVER


    1. A015BV6

      Detach the 2 claws and remove the steering wheel cover.

  4. REMOVE LOWER NO. 2 STEERING WHEEL COVER


    1. A0159MPE01

      Detach the 2 claws and remove the steering wheel cover.

  5. REMOVE STEERING PAD


    1. A0158E8E01

      Using a T30 "TORX" socket wrench, loosen the 2 screws until the groove along the screw circumference catches on the screw case.

    2. A0155SD

      Pull out the steering pad from the steering wheel, as shown in the illustration. Then support the steering pad with one hand.

      Note

      When removing the steering pad, do not pull the airbag wire harness.

    3. Disconnect the horn connector.

    4. Disconnect the 2 connectors and remove the steering pad.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

  6. REMOVE STEERING WHEEL ASSEMBLY


    1. Remove the steering wheel set nut.

    2. A0155JKE03
      Text in Illustration
      *a Matchmark
      *b Hold
      *c Turn

      Put matchmarks on the steering wheel and main shaft.

    3. Using SST, remove the steering wheel assembly.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05011 )

  7. REMOVE LOWER STEERING COLUMN COVER


    1. A0158ZO

      Remove the 3 screws.

    2. Detach the 2 claws to remove the lower steering column cover.

      Note

      Do not damage the tilt and telescopic switch.

  8. REMOVE UPPER STEERING COLUMN COVER


    1. A015A4N

      Detach the 4 clips.

    2. Detach the claw to remove the upper steering column cover.

  9. REMOVE SPIRAL CABLE


    1. A01588U

      Disconnect the connectors from the spiral cable with steering sensor.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

    2. Detach the 3 claws and remove the spiral cable with steering sensor.

    3. A0158HRE03

      Detach the 6 claws and remove the spiral cable from the steering sensor.