HOOD LOCK CONTROL CABLE ASSEMBLY INSTALLATION


  1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY


    1. Pass the hood lock control cable assembly into the engine compartment.

    2. Pass the cable through the upper radiator support.

    3. Engage the hood cable grommet.

    4. Engage the 5 clamps and install the hood lock control cable assembly.

  2. INSTALL HOOD LOCK ASSEMBLY


    1. A01G6IJ

      Apply MP grease to the sliding areas of the lock.

    2. Connect the hood lock control cable assembly.

    3. Install the hood lock assembly with the 3 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

    4. Engage the clamp.

    5. Connect the connector.

  3. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    1. Connect the hood lock control cable assembly and install the hood lock control lever sub-assembly.

  4. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    1. Engage the claw and 2 guides to connect the hood lock control lever sub-assembly.

  5. INSTALL COWL SIDE TRIM BOARD LH


    1. Engage the clip and claw.

    2. Install the cowl side trim board LH with the clip.

  6. INSTALL FRONT DOOR SCUFF PLATE LH


    1. Engage the 10 claws to install the front door scuff plate LH.

  7. INSTALL FRONT FENDER LINER LH

    Tech Tips

    Use the same procedure for the RH side and LH side Click here.

  8. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH

    Tech Tips

    Use the same procedure for the RH side and LH side Click here.

  9. INSTALL FRONT WHEEL LH

    Torque:
    103 N*m  { 1049 kgf*cm, 76 ft.*lbf }

  10. INSTALL COOL AIR INTAKE DUCT SEAL


    1. Install the cool air intake duct seal with the 9 clips.

  11. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)

    Click here

  12. ADJUST HOOD SUB-ASSEMBLY

    Click here