FRONT SPEED SENSOR INSTALLATION

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

  • If the sensor rotor needs to be replaced, replace the front drive outboard joint shaft assembly.


  1. INSTALL FRONT SPEED SENSOR


    1. Install the front speed sensor to the steering knuckle with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note


      • Prevent foreign matter from attaching to the front speed sensor tip.

      • Firmly insert the front speed sensor body into the steering knuckle before tightening the bolt.

      • After installing the front speed sensor to the steering knuckle, make sure that there is no clearance between the front speed sensor stay and steering knuckle. Also make sure that no foreign matter is stuck between the parts.

    2. A01G8J7E02
      Text in Illustration
      *1 Front Speed Sensor Clamp
      *2 Front Flexible Hose
      *a Claw

      Install the front speed sensor clamp and front flexible hose to the front shock absorber assembly with the bolt.

      Torque:
      19 N*m  { 192 kgf*cm, 14 ft.*lbf }

      Note


      • Do not twist the wire harness for the front speed sensor when installing it.

      • Securely set the 2 claws of the front speed sensor clamp to the shock absorber bracket.

      • A bolt tightens the front flexible hose and front speed sensor together. Make sure that the front flexible hose is positioned over the front speed sensor.

    3. Engage the clamp to the front shock absorber assembly.

    4. A01G9A6E01
      Text in Illustration
      *a Claw

      Install the front speed sensor clamp to the body with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note


      • Do not twist the wire harness for the front speed sensor when installing it.

      • Securely set the claw of the front speed sensor clamp to the body.

    5. Engage the clamp and connect the connector.

  2. INSTALL FRONT FENDER LINER

    Tech Tips

    Use the same procedure for the LH side and RH side Click here.

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. CHECK FOR SPEED SENSOR SIGNAL

    Click here