STEERING WHEEL INSTALLATION

CAUTION / NOTICE / HINT

Note


  • Do not replace the spiral cable with sensor sub-assembly with the auxiliary battery connected and the power switch on (IG).

  • Do not rotate the spiral cable with sensor sub-assembly without the steering wheel with the auxiliary battery connected and the power switch on (IG).

  • Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.

PROCEDURE


  1. INSTALL STEERING PAD SWITCH ASSEMBLY

    Click here

  2. INSTALL CRUISE CONTROL MAIN SWITCH

    Click here

  3. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  4. INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

    Click here

  5. INSTALL STEERING WHEEL ASSEMBLY


    1. A0009PME01
      Text in Illustration
      *a Matchmark

      Install the steering wheel assembly aligning the matchmarks on the steering wheel assembly and steering main shaft.

    2. Install the steering wheel assembly set nut.

      Torque:
      50 N*m  { 510 kgf*cm, 37 ft.*lbf }

    3. w/ Pre-crash Safety System:


      1. Connect the connector.

    4. Connect each connector to the spiral cable sub-assembly.

  6. CHECK STEERING WHEEL CENTER POINT

  7. INSTALL HORN BUTTON ASSEMBLY

    Click here