FRONT BRAKE FLEXIBLE HOSE REMOVAL

CAUTION / NOTICE / HINT

Note

If the left and right hoses are disconnected at the same time, be sure to place a mark on each hose to indicate its installation position.

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work Click here

  2. DISABLE BRAKE CONTROL (for LHD)

    Click here

  3. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY (for RHD)

    Tech Tips

    Use the same procedure as for LHD Click here.

  4. REMOVE FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)

    Click here

  5. DISABLE BRAKE CONTROL (for RHD)

    Click here

  6. REMOVE FRONT WHEEL

  7. DRAIN BRAKE FLUID

    Note

    If brake fluid leaks onto any painted surface, immediately wash it off.

  8. REMOVE FRONT FLEXIBLE HOSE


    1. A0008SE

      Remove the union bolt and gasket, and separate the front flexible hose from the front disc brake cylinder assembly.

    2. A0006AEE07
      Text in Illustration
      *1 Clip

      Using a union nut wrench, disconnect the brake line while holding the front flexible hose with a wrench.

      Note


      • Do not bend or damage the brake line.

      • Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting points.

    3. Remove the clip.

    4. A0005UM

      Remove the bolt and front flexible hose from the front shock absorber assembly.