REAR BRAKE FLEXIBLE HOSE REMOVAL

CAUTION / NOTICE / HINT

Note

If the left and right hoses are disconnected at the same time, be sure to place a mark on each hose to indicate its installation position.

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work Click here.

  2. DISABLE BRAKE CONTROL (for LHD)

    Click here

  3. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY (for RHD)

    Tech Tips

    Use the same procedure as for LHD Click here.

  4. REMOVE FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)

    Click here

  5. DISABLE BRAKE CONTROL (for RHD)

    Click here

  6. REMOVE REAR WHEEL

  7. DRAIN BRAKE FLUID

    Note

    If brake fluid leaks onto any painted surface, immediately wash it off.

  8. REMOVE REAR FLEXIBLE HOSE


    1. A00045BE06
      Text in Illustration
      *1 Brake Line
      *2 Clip
      *3 Bolt

      Using a union nut wrench, disconnect the brake line while holding the rear flexible hose with a wrench.

      Note


      • Do not bend or damage the brake line.

      • Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting points.

    2. Remove the clip from the rear flexible hose.

    3. Remove the bolt.

    4. A0004NM

      Remove the union bolt, gasket and rear flexible hose.