REAR SPEED SENSOR REMOVAL

CAUTION / NOTICE / HINT

Note

When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.

Tech Tips

Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
If the sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.
The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor malfunctions, replace the rear axle hub and bearing assembly.

PROCEDURE

PRECAUTION

Note

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work Click here.
REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY (for RHD)

Tech Tips

Use the same procedure as for LHD Click here.
REMOVE FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)

Click here
DISABLE BRAKE CONTROL (for LHD)

Click here
DISABLE BRAKE CONTROL (for RHD)

Click here
REMOVE REAR WHEEL
SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

Click here
REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG

Click here
REMOVE REAR DISC

Click here
DISCONNECT SKID CONTROL SENSOR WIRE
1. Using a screwdriver, disconnect the connector from the rear speed sensor.
  
  Note
  
  Be careful not to damage the rear speed sensor.
REMOVE REAR AXLE HUB AND BEARING ASSEMBLY
1. Remove the rear axle hub and bearing assembly Click here.
  Tech Tips
  - The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor malfunctions, replace the rear axle hub and bearing assembly.
  - If the sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.