СВЕЧА НАКАЛИВАНИЯ СНЯТИЕ


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE NO. 1 ENGINE COVER


    1. A01INMI

      Возьмитесь сзади за крышку двигателя № 1 и медленно поднимите ее, чтобы разъединить задний фиксатор крышки двигателя № 1. Продолжайте поднимать крышку двигателя № 1, чтобы освободить 3 передних и боковых фиксатора крышки двигателя № 1, после чего снимите крышку двигателя № 1.

      Note

      Попытка освободить задний и передние фиксаторы за один прием может привести к поломке крышки.

  4. REMOVE NO. 2 EGR PIPE SUB-ASSEMBLY


    1. A01IOQA

      Отсоедините разъем электрического клапана управления РОГ.

    2. A01IPRKE01
      Обозначения на рисунке
      *1 Гайка

      Выверните 3 болта, отверните 2 гайки и снимите трубу РОГ № 2 в сборе и 2 прокладки.

  5. REMOVE ENGINE COVER BRACKET


    1. A01IS0W

      Remove the bolt, nut and engine cover bracket.

  6. DISCONNECT ENGINE WIRE


    1. A01ISJC

      for DPF:

      Disconnect the glow connector.

    2. Remove the bolt and disconnect the engine wire so that the glow plugs can be removed in a later step.

  7. REMOVE NO. 1 GLOW PLUG CONNECTOR (for DPF)


    1. A01IP8U

      Remove the 4 grommets.

    2. A01IPP9

      Detach the clamp from the bracket.

    3. A01IS2A

      Remove the 4 nuts and No. 1 glow plug connector.

  8. REMOVE NO. 1 GLOW PLUG CONNECTOR (for CCo)


    1. A01IOVD

      Remove the 5 grommets.

    2. A01IP2FE01
      Text in Illustration
      *1 Wire Harness

      Remove the nut and disconnect the wire harness.

    3. Remove the 4 nuts and No. 1 glow plug connector.

  9. REMOVE GLOW PLUG ASSEMBLY


    1. A01IQBH

      Using a 10 mm deep socket wrench, remove the 4 glow plugs.