LUBRICATION SYSTEM (for CCo) ПРОВЕРКА БЕЗ СНЯТИЯ С АВТОМОБИЛЯ

INSPECT OIL QUALITY

1. Check the engine oil for deterioration, water contamination, discoloration or thinning.

   If the quality is visibly poor, replace the engine oil and oil filter element (Click here).

INSPECT ENGINE OIL LEVEL

1. Warm up the engine, stop the engine and wait 5 minutes. The engine oil level should be between the dipstick low level mark and full level mark.

   If low, check for leakage and add oil up to the full level mark.

   Note:

   Do not fill engine oil above the full level mark.

   Tip:

   A certain amount of engine oil will be consumed while driving. In the following situations, oil consumption may increase, and engine oil may need to be refilled in between oil maintenance intervals.

   
   

   • When the engine is new, for example directly after purchasing the vehicle or after replacing the engine.

   • If low quality oil or oil of an inappropriate viscosity is used.

   • When driving at high engine speed or with a heavy load, (when towing, or), when driving while accelerating or decelerating frequently.

   • When leaving the idling for a long time, or when driving frequently through heavy traffic.

   When judging the amount of oil consumption, keep in mind that the oil may have become diluted, making it difficult to judge the true level accurately.

INSPECT ENGINE OIL PRESSURE

1. Remove the engine oil pressure switch (Click here).

2. 

   Install an oil pressure gauge with an adapter.

   Table 1. Text in Illustration

   *1	Oil Pressure Gauge
   *2	Adapter

3. Warm up the engine.

4. Measure the engine oil pressure.

   Standard Oil Pressure
   Condition Specified Condition Idle 29 kPa (0.3 kgf/cm2, 4.2 psi) or higher 4500 rpm 245 kPa (2.5 kgf/cm2, 36 psi) or higher

   If the pressure is not as specified, check the oil pump.

5. Remove the oil pressure gauge and adapter.

6. Install the engine oil pressure switch (Click here).

7. Inspect for engine oil leaks (Click here).