REMOVE NO. 1 ENGINE UNDER COVER
Remove the 9 clips and fold back the No. 1 engine under cover.
Tech Tips
It is not necessary to fully remove the No. 1 engine under cover. Partially remove it so that the oil can be replaced in a later step.
DRAIN ENGINE OIL
Remove the oil filler cap.
Remove the oil pan drain plug and gasket, and then drain the engine oil into a container.
Install a new gasket and the oil pan drain plug.
REMOVE NO. 1 ENGINE COVER
Hold the rear of the No. 1 engine cover and slowly raise it to detach the clip on the rear of the No. 1 engine cover. Continue to raise the No. 1 engine cover to detach the 3 clips on the front and side of the No. 1 engine cover and remove the No. 1 engine cover.
Note
Attempting to disengage both front and rear clips at the same time may cause the cover to break.
REMOVE RADIATOR SUPPORT OPENING COVER
Remove the 3 clips.
Detach the 4 hooks and remove the radiator support opening cover.
REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY
Disconnect the engine oil pressure switch connector.
Using a 24 mm deep socket wrench, remove the engine oil pressure switch assembly.