INTAKE MANIFOLD REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work Click here.

  2. DISCHARGE FUEL SYSTEM PRESSURE

    Click here

  3. REMOVE LUGGAGE TRIM SERVICE HOLE COVER

    Click here

  4. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

  5. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

    Click here

  6. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

    Click here

  7. REMOVE FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY

    Click here

  8. REMOVE INTAKE FLANGE


    1. A0005F0

      Remove the 4 bolts and intake flange.

    2. Remove the gasket from the intake manifold.

  9. REMOVE MANIFOLD ABSOLUTE PRESSURE SENSOR

    Click here

  10. SEPARATE INTAKE MANIFOLD


    1. A000405

      Disconnect the No. 2 ventilation hose from the intake manifold.

    2. A00085T

      Disconnect the heated oxygen sensor connector.

    3. A0006GN

      Disconnect the 6 wire harness clamps.

    4. A0005TO

      Remove the 6 bolts to separate the intake manifold from the engine assembly.

  11. DISCONNECT FUEL TUBE SUB-ASSEMBLY

    Click here

  12. REMOVE FUEL DELIVERY PIPE

    Click here

  13. REMOVE INTAKE MANIFOLD


    1. Remove the intake manifold from the vehicle.

    2. A0004GB

      Remove the gasket from the intake manifold.

    3. A0007WM

      Remove the bolt and wire harness clamp bracket.

    4. A00050I

      Remove the vacuum hose from the intake manifold.

    5. A0009GM

      Remove the fuel vapor feed hose from the intake manifold.