OIL PRESSURE SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the oil pressure sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Replacement of oil pressure sensor

Perform the following procedures in the order shown:


  1. Reset memory

  2. Deceleration sensor zero point calibration

  3. CVT oil pressure calibration

 Deterioration of fuel efficiency

Click here

PROCEDURE


  1. REMOVE FRONT WHEEL LH

    Click here

  2. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  3. REMOVE REAR ENGINE UNDER COVER LH

    Click here

  4. REMOVE OIL PRESSURE SENSOR

    A001U3R

    1. Disconnect the oil pressure sensor connector.

    2. A001W2XN01

      Using SST, remove the oil pressure sensor from the continuously variable transaxle assembly.

      SST
      09326-22011