FRONT CRANKSHAFT OIL SEAL REMOVAL

PROCEDURE


  1. REMOVE FRONT WHEEL RH

    Click here

  2. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  3. REMOVE REAR ENGINE UNDER COVER RH

    Click here

  4. REMOVE REAR SIDE RAIL REINFORCEMENT SUB-ASSEMBLY RH

    Click here

  5. REMOVE FAN AND GENERATOR V BELT

    Click here

  6. REMOVE CRANKSHAFT PULLEY ASSEMBLY


    1. A001VY0C02
      *a Hold
      *b Turn

      Using SST, hold the crankshaft pulley assembly and loosen the crankshaft pulley set bolt. Further loosen the crankshaft pulley set bolt until 2 or 3 threads remain screwed into the crankshaft.

      SST
      09213-70011   ( 09213-70020 )
      09330-00021
    2. A001U9IC02
      *1 Crankshaft Pulley Set Bolt
      *a Hold
      *b Turn

      Using SST and the crankshaft pulley set bolt, remove the crankshaft pulley assembly and crankshaft pulley set bolt.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05021 )

      Note

      Apply lubricant to the threads and end of SST.

  7. REMOVE TIMING CHAIN COVER OIL SEAL


    1. A001UW8C02
      *a Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, pry out the timing chain cover oil seal.

      Note

      After removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.