REAR DISC BRAKE PAD REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • The following procedure is for the LH side.

  • Use the same procedure for the RH side and LH side.

PROCEDURE


  1. REMOVE REAR WHEEL

    Click here

  2. DRAIN BRAKE FLUID

    Note

    If brake fluid leaks onto any painted surface, immediately wash it off.

  3. REMOVE REAR DISC BRAKE PAD

    CAUTION:


    • A002YLR

      After lifting up the rear disc brake cylinder assembly, secure it in place before performing any work on it.

    • The rear disc brake cylinder assembly could fall, pinching hands or fingers and causing injury.


    1. A001T8V

      Disconnect the No. 2 parking brake wire assembly connector from the parking brake actuator assembly.

    2. A001W9JC01
      *a Hold
      *b Turn

      Hold the rear disc brake cylinder slide pin, and remove the bolt.

    3. A001TUU

      Pull the rear disc brake cylinder assembly upward.

    4. Remove the 2 rear disc brake pads from the rear disc brake cylinder mounting.

  4. REMOVE REAR DISC BRAKE ANTI-SQUEAL SHIM KIT


    1. Remove the rear No. 1 disc brake anti-squeal shim and rear No. 2 disc brake anti-squeal shim from each rear disc brake pad.

    2. A001T5N

      Using a screwdriver, remove the rear disc brake pad wear indicator plate from each rear disc brake pad.