FRONT DOOR BELT MOULDING REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front door belt moulding assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link

  • Front door glass

  • Front door glass run

 Initialize power window control system

  • Auto up and down function

  • Jam protection function

  • Remote control function

  • Key-linked function

  • Wireless transmitter-linked function

  • Key-off operation function

  • Catch protection function

  • Window open warning function

Click here

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. CAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work.

    Click here

  2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

  4. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY

    Click here

  5. REMOVE FRONT DOOR GLASS INNER WEATHERSTRIP

    Click here

  6. REMOVE FRONT DOOR SERVICE HOLE COVER

    Click here

  7. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

    Click here

  8. REMOVE FRONT DOOR GLASS RUN

    Click here

  9. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY

    Click here

  10. REMOVE FRONT DOOR FRONT LOWER FRAME SUB-ASSEMBLY

    Click here

  11. REMOVE FRONT DOOR FIX WINDOW GLASS

    Click here

  12. REMOVE FRONT DOOR BELT MOULDING ASSEMBLY


    1. A01MH68C02
      B000ZUW Protective Tape

      Apply protective tape around the front door belt moulding assembly.

    2. Using a screwdriver, disengage the claws to remove the front door belt moulding assembly as shown in the illustration.

      A01MGOIC02
      B006JEG Push - -
      B006JFV Remove in this Direction - -