HEIGHT CONTROL SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear height control sensor sub-assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Rear height control sensor sub-assembly

  • Vehicle information registration for the headlight light control ECU sub-assembly LH

  • Initialization of the headlight light control ECU sub-assembly LH

 Automatic headlight beam level control system

Click here

PROCEDURE


  1. CAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

  4. REMOVE NO. 2 FLOOR UNDER COVER

    Click here

  5. REMOVE NO. 1 FLOOR UNDER COVER

    Click here

  6. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY


    1. A01MFM6

      Disconnect the connector.

    2. A01MG4J

      Remove the 3 bolts.

    3. Disengage the hook to remove the rear height control sensor sub-assembly.

      Note

      If the rear height control sensor sub-assembly has been dropped, replace it with a new one.