WIPER SWITCH REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work.

    Click here

  2. CHANGE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM SETTINGS

    Click here

  3. REMOVE LUGGAGE TRIM SERVICE HOLE COVER

    Click here

  4. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

  5. REMOVE LOWER STEERING COLUMN COVER


    1. A01MIN3

      Turn the steering wheel assembly to the left and remove the screw.

    2. A01MIAC

      Turn the steering wheel assembly to the right and remove the screw.

    3. A01MJDS

      Remove the screw.

    4. A01MFMF

      Push the left side of the lower steering column cover to disengage the claw and guides.

    5. Push the right side of the lower steering column cover to disengage the claw and guides to remove the lower steering column cover.

  6. REMOVE UPPER STEERING COLUMN COVER


    1. A01MI44

      Disengage the clips and guides to separate the meter hood spacer.

    2. A01MJIN

      Disengage the claw and guides to remove the upper steering column cover.

  7. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY


    1. A01MHTEC01
      *a Protective tape
      B006JFV Remove in this Direction

      Disconnect the 2 connectors.

    2. Using a screwdriver with its tip wrapped in protective tape, disengage the claw to remove the windshield wiper switch assembly as shown in the illustration.

      Note

      If the claw is pulled with excessive force, it may break.