POWER WINDOW REGULATOR MOTOR(for Rear Side) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the power window regulator motor assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effects/Inoperative when not Performed Link

  • Removal/installation of Rear door window regulator assembly

  • Removal/installation of Power window regulator motor assembly

  • Removal/installation of Rear door glass sub-assembly

 Initialize Power Window Control System

  • Auto up and down function

  • Jam protection function

  • Remote control function

  • Key-off operation function

  • Catch protection function

  • Window open warning function

Click here

Tech Tips


  • Use the same procedure for both the RH and LH side.

  • The procedure described below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

  4. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  5. REMOVE REAR DOOR ARMREST COVER

    Click here

  6. REMOVE NO. 1 REAR DOOR STIFFENER CUSHION

    Click here

  7. REMOVE COURTESY LIGHT ASSEMBLY

    Click here

  8. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  9. REMOVE REAR DOOR GLASS INNER WEATHERSTRIP

    Click here

  10. REMOVE REAR DOOR SERVICE HOLE COVER

    Click here

  11. REMOVE REAR DOOR GLASS RUN

    Click here

  12. REMOVE REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY

    Click here

  13. REMOVE REAR DOOR GLASS SUB-ASSEMBLY

    Click here

  14. REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY

    Click here

  15. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY


    1. A01MHNG

      Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor assembly.