FRONT SEAT OUTER BELT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for both the RH and LH side.

  • The procedure described below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work.

    Click here

  2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL


    1. Disconnect the cable from the negative (-) auxiliary battery terminal.

      Click here

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

      B006JL1

  4. REMOVE FRONT DOOR SCUFF PLATE

    Click here

  5. REMOVE REAR DOOR SCUFF PLATE

    Click here

  6. REMOVE LAP BELT OUTER ANCHOR COVER

    Click here

  7. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY

    Click here

  8. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP


    1. Disconnect the front door opening trim weatherstrip.

  9. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP


    1. Disconnect rear door opening trim weatherstrip.

  10. REMOVE CENTER PILLAR LOWER GARNISH

    Click here

  11. REMOVE CENTER PILLAR GARNISH ASSEMBLY

    Click here

  12. REMOVE FRONT SEAT OUTER BELT ASSEMBLY


    1. A01MJRM

      Remove the nut to separate the shoulder anchor of the front seat outer belt assembly.

    2. A01MK2JC01
      *1 Locking Button
      *a Protective Tape

      Using a screwdriver with its tip wrapped in protective tape, pull out the locking button to release the lock and disconnect the pretensioner connector as shown in the illustration.

    3. Disconnect the pretensioner connector.

    4. A01MIW6

      Remove the bolt.

    5. A01MJFS

      Disengage the guides to remove the front seat outer belt assembly.

  13. REMOVE FRONT SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY


    1. A01MG65

      Remove the 2 bolts.

    2. Disengage the guide to remove the front shoulder belt anchor plate sub-assembly.

  14. REMOVE FRONT SEAT BELT RETRACTOR COVER


    1. A01MHLX

      Disengage the guide to remove the front seat belt retractor cover.