REAR SEAT OUTER BELT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for both the RH and LH side.

  • The procedure described below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. REMOVE CENTER STOP LIGHT SET

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL


    1. Disconnect the cable from the negative (-) auxiliary battery terminal.

      Click here

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

      B006JL1

  4. REMOVE REAR SEAT ASSEMBLY

    Click here

  5. REMOVE REAR DOOR SCUFF PLATE LH

    Click here

  6. REMOVE REAR DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedure as for the LH side.

  7. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH


    1. Disconnect the rear door opening trim weatherstrip LH.

  8. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH


    1. Disconnect the rear door opening trim weatherstrip RH.

  9. REMOVE REAR SEAT SIDE GARNISH LH

    Click here

  10. REMOVE REAR SEAT SIDE GARNISH RH

    Tech Tips

    Use the same procedure as for the LH side.

  11. REMOVE ROOF SIDE INNER GARNISH ASSEMBLY LH

    Click here

  12. REMOVE ROOF SIDE INNER GARNISH ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.

  13. REMOVE REAR SEAT SHOULDER BELT COVER


    1. B006JIKC01
      B006JFV Remove in this Direction (1)
      B006JHL Remove in this Direction (2)

      Disengage the claws and guides to remove the rear seat shoulder belt cover as shown in the illustration.

      Tech Tips

      Use the same procedure to remove the opposite side.

  14. DISCONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY LH


    1. B006JD7

      Disconnect the floor anchor of the rear seat 3 point type belt assembly outer LH.

  15. DISCONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.

  16. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY


    1. Disengage the clips as shown in the illustration.

      B006JG0C02
      B006JDZ Place Hands Here B006JFV Remove in this Direction

    2. Disengage the guides shown in the illustration, separate the rear seat 3 point type belt assembly outer LH and rear seat 3 point type belt assembly outer RH to remove the package tray trim panel assembly.

      B006JH1C02
      B006JFV Remove in this Direction - -

  17. REMOVE REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY


    1. B006JL3C01
      *1 Locking Button
      *a Protective Tape

      Using a screwdriver with its tip wrapped in protective tape, pull out the locking button to release the lock and disconnect the pretensioner connector as shown in the illustration.

    2. B006JDS

      Remove the 2 bolts.

    3. B006JL5

      Disengage the guide to remove the rear seat 3 point type outer belt assembly.

  18. REMOVE SEAT BELT RETRACTOR COVER


    1. B006JLK

      Disengage the guide to remove the seat belt retractor cover.