SRS SEAT CUSHION AIRBAG ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front seat cushion airbag assembly RH removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Replace front seat cushion airbag assembly RH FC stack assembly on-vehicle inspection* The FC stack assembly may have been damaged.

Click here

*: Perform an on-vehicle inspection of the FC stack assembly only if the vehicle has been subjected to a strong impact.

CAUTION:

Be sure to read Precaution thoroughly before servicing.

A0026SW

Click here

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work.

    Click here

  2. REMOVE FRONT SEAT CUSHION WITH COVER PAD RH

    Click here

  3. REMOVE FRONT SEAT CUSHION AIRBAG ASSEMBLY RH


    1. A0026MF

      Disengage the clamps.

    2. A00268H

      Remove the 3 nuts.

    3. Disengage the clamps.

    4. A0026K7

      Remove the front seat cushion airbag assembly RH.

      Note


      • The nuts must not be reused.

      • Make sure that the front seat cushion spring sub-assembly RH is not deformed. If it is, replace it with a new one.