CURTAIN SHIELD AIRBAG ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the curtain shield airbag assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure	Necessary Procedure	Effect/Inoperative when not Performed	Link
Replace curtain shield airbag assembly	FC stack assembly on-vehicle inspection*	The FC stack assembly may have been damaged.	Click here

*: Perform an on-vehicle inspection of the FC stack assembly only if the vehicle has been subjected to a strong impact.

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click here

Tech Tips

Use the same procedure for the RH and LH sides.
The procedure listed below is LH side.

PROCEDURE

PRECAUTION

Note

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work.

Click here
REMOVE LUGGAGE TRIM SERVICE HOLE COVER

Click here
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
1. Disconnect the cable from the negative (-) auxiliary battery terminal.
  
  Click here
  CAUTION:
  
  Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
  
  If the airbag deploys for any reason, it may cause a serious accident.
REMOVE ROOF HEADLINING ASSEMBLY

Click here
REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY
CAUTION:
- When storing the curtain shield airbag assembly, keep the airbag deployment side facing upward.
- If the airbag deploys for any reason, it may cause a serious accident.
1. Check that the power switch is off.
2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
  CAUTION:
  - Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
  - If the airbag deploys for any reason, it may cause a serious accident.
3. *1 Locking Button
  
  *a Protective Tape
  
  Using a screwdriver with its tip wrapped with protective tape, release the locking button.
  
  Note
  
  When disconnecting any airbag connector, take care not to damage the airbag wire harness.
4. Remove the 12 bolts.
5. Disengage the clips and pins to remove the curtain shield airbag assembly.
6. Remove the clips from the curtain shield airbag assembly.

*1	Locking Button
*a	Protective Tape