FRONT PASSENGER AIRBAG ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the instrument panel passenger without door airbag assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Replace instrument panel passenger without door airbag assembly FC stack assembly on-vehicle inspection* The FC stack assembly may have been damaged.

Click here

*: Perform an on-vehicle inspection of the FC stack assembly only if the vehicle has been subjected to a strong impact.

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click here

A0026SW

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL


    1. Disconnect the cable from the negative (-) auxiliary battery terminal.

      Click here

      CAUTION:


      • Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

      • If the airbag deploys for any reason, it may cause a serious accident.

      B006JL1

  4. REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY

    Click here

  5. REMOVE INSTRUMENT PANEL PASSENGER WITHOUT DOOR AIRBAG ASSEMBLY

    CAUTION:


    • When strong the instrument panel passenger airbag without door assembly, keep the airbag deployment side facing upward.

    • If the airbag deploys for any reason, it may cause a serious accident.


    1. A0026Q6

      Using a clip remover, disengage the 3 clamps to separate the wire harness.

    2. A00269J

      Remove the 2 screws.

    3. A0026J9

      While bending the side of the airbag door on the vehicle rearward side, disengage the hooks.

    4. A0026D9

      Disengage the hooks from vehicle front side of the airbag door, and remove the instrument panel passenger without door airbag assembly.

  6. REMOVE NO. 2 INSTRUMENT PANEL WIRE


    1. A0026J1C01
      *1 Locking Button
      *a Protective Tape

      Using a screwdriver with its tip wrapped in protective tape, release the locking button.

    2. Disconnect the airbag connector to remove the No. 2 instrument panel wire.