AIRBAG SYSTEM, Diagnostic DTC:B1610/13

DTC Code DTC Name
B1610/13 Front Airbag Sensor RH Malfunction

DESCRIPTION

The front airbag sensor RH consists of a diagnostic circuit and frontal deceleration sensor, etc.

If the airbag sensor assembly receives signals from the frontal deceleration sensor, it determines whether the SRS should be activated.

DTC B1610/13 is stored when a malfunction is detected in the front airbag sensor RH circuit.

DTC No. Detection Item DTC Detection Condition Trouble Area
B1610/13 Front Airbag Sensor RH Malfunction

Either condition is met:


  • A front airbag sensor RH malfunction.

  • An airbag sensor assembly malfunction.

  • Front airbag sensor RH

  • Airbag sensor assembly

WIRING DIAGRAM

A01MICRE72
*a Front Airbag Sensor RH
*b Airbag Sensor Assembly

CAUTION / NOTICE / HINT

Note


  • After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  • When disconnecting the cable from the negative (-) auxiliary battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected.

    Click here

  • After replacing the airbag sensor assembly, refer to initialization.

    Click here

PROCEDURE


  1. CHECK FRONT AIRBAG SENSOR RH


    1. A01MJILC18
      *1 Front Airbag Sensor LH
      *2 Airbag Sensor Assembly

      Turn the power switch off.

    2. Disconnect the cable from the negative (-) auxiliary battery terminal, and wait for at least 90 seconds.

    3. Interchange the front airbag sensor RH with LH and connect the connectors to them.

    4. Connect the cable to the negative (-) auxiliary battery terminal, and wait for at least 2 seconds.

    5. Turn the power switch on (IG), and wait for at least 60 seconds.

    6. Clear the DTCs stored in memory.

      Click here


      Body Electrical > SRS Airbag > Clear DTCs

    7. Turn the power switch off.

    8. Turn the power switch on (IG), and wait for at least 60 seconds.

    9. Check for DTCs.

      Click here


      Body Electrical > SRS Airbag > Trouble Codes
      Result
      Result Proceed to
      DTC B1610/13 is output A
      DTC B1615/14 is output B
      DTCs B1610/13 and B1615/14 are not output C

      Tech Tips

      Codes other than DTCs B1610/13 and B1615/14 may be output at this time, but they are not related to this check.

    10. Turn the power switch off.

    11. Disconnect the cable from the negative (-) auxiliary battery terminal, and wait for at least 90 seconds.

    12. Return the front airbag sensor LH and RH to their original positions and connect the connectors to them.


    A

    REPLACE AIRBAG SENSOR ASSEMBLY Click here

    B

    REPLACE FRONT AIRBAG SENSOR RH Click here

    C

    USE SIMULATION METHOD TO CHECK Click here