INTEGRATION RELAY REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

  4. REMOVE NO. 1 RELAY BLOCK COVER


    1. A01MGKOC01
      B006JFV Remove in this Direction (1)
      B006JHL Remove in this Direction (2)

      Disengage the claws to remove the No. 1 relay block cover as shown in the illustration.

  5. REMOVE NO. 1 INTEGRATION RELAY


    1. A01MFW7C01
      *a Protective Tape
      B006JFV Remove in this Direction

      Using a screwdriver with its tip wrapped with protective tape, disengage the claws.

    2. Pull out the No. 1 integration relay as shown in the illustration.

    3. A01MJQT

      Disconnect the 3 connectors to remove the No. 1 integration relay.

      Note

      Do not impact the No. 1 integration relay.