TILT AND TELESCOPIC MANUAL SWITCH REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery notice before proceeding with work.

    Click here

  2. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM


    1. Disengage the auto tilt away function by changing the customize parameter.

      Click here

      Note

      Record the current customize parameter setting (whether the auto tilt away function is enabled or disabled) in order to restore the current setting after finishing the operation.

      Tech Tips

      Performing the above operation causes the auto tilt away function to be disabled when the power switch is turned off.

    2. Turn the power switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.

  3. REMOVE LUGGAGE TRIM SERVICE HOLE COVER

    Click here

  4. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

  5. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  6. REMOVE LOWER STEERING COLUMN COVER


    1. A01MJDT

      Starting with the steering wheel assembly in the straight-ahead position, turn the steering wheel assembly 90° to the left and right to remove the 3 screws.

    2. A01MHAA

      Disengage the 2 claws and 6 guides to remove the lower steering column cover.

      Note

      Do not damage the tilt and telescopic switch.

  7. REMOVE TILT AND TELESCOPIC SWITCH

    A01MFXOC01
    B006JFV Remove in this Direction

    1. Disconnect the connector.

    2. Disengage the claw and pull out the tilt and telescopic switch.

      Note

      Pushing on the claw too hard will break the claw.