DRIVING SUPPORT ECU(for LHD) REMOVAL

PROCEDURE

1. PRECAUTION

   Note

   After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

   Click here

2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER

   Click here

3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

   Click here

4. REMOVE FRONT DOOR SCUFF PLATE RH

   Tech Tips

   Perform the same procedure as for the LH side.

   Click here

5. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

6. REMOVE COWL SIDE TRIM BOARD RH

   Tech Tips

   Perform the same procedure as for the LH side.

   Click here

7. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY

   Click here

8. REMOVE INSTRUMENT CENTER PANEL REGISTER ASSEMBLY

   Click here

9. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY

   Click here

10. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH

    Tech Tips

    Perform the same procedure as for the LH side.

    Click here

11. REMOVE INSTRUMENT SIDE PANEL RH

    Click here

12. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

    Click here

13. REMOVE DRIVING SUPPORT ECU ASSEMBLY

    
    

    1. 

       Disconnect the connecter.

    2. Remove the nut.

    3. Disengage the claw to remove the driving support ECU assembly.